What is the effect of gas discharge during mold injection?

Gas is often produced in injection molds and may be related to the following:
The air contained in the casting system and the mold cavity.
Some raw materials contain moisture that is not removed by drying, and they are vaporized into water vapor at high temperatures.
Due to the high temperature during injection molding, some unstable plastics will decompose and produce gas.
Some additives in plastic materials volatilize or react with each other to form a gas.
At the same time, the reason for poor exhaustion is also needed to find out as soon as possible. Poor exhaust of the injection mold also causes problems for the plastic parts. The main performance is as follows:
In the injection molding process, the melt will replace the gas in the cavity. If the gas is not discharged in time, the melt filling will be difficult, resulting in insufficient injection volume to fill the cavity.
Excessive gas removal creates high pressure in the cavity and penetrates into the interior of the plastic at a certain degree of compression, causing quality defects such as voids, pores, texture and silver streaks.
Due to the high compression of the gas, the temperature in the cavity rises sharply, which causes decomposition and burning of the surrounding melt, causing local carbonization and charring of the plastic part. It mainly occurs at the junction of the two melts at the gate flange.
The gas is not well removed, so that the melt velocity entering each cavity is different, so flow marks and fusion marks are easily formed, and the mechanical properties of the plastic parts are lowered.
Due to the obstruction of gas in the cavity, the filling speed is reduced, the molding cycle is affected, and the taxation efficiency is lowered.
Distribution of bubbles in plastic parts:
The bubbles generated by the accumulation of air in the cavity are often distributed at the portion opposite to the gate.
Bubbles generated by decomposition or chemical reaction in the plastic raw material are distributed along the thickness of the plastic part.
The bubbles generated by the vaporization of residual water in the plastic raw material are irregularly distributed on the entire plastic part.

Tube Shaped Tea Infuser

Fine Tea Strainer,Tea Infuser For Loose Tea,Stainless Steel Tube Shape Tea Infuser,Tube Shape Stainless Steel Tea Infuser

YANGJIANG VOSSEN INDUSTRY AND TRADE CO.,LTD , https://www.cnvossen.com

Posted on